Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

VERIFY THE DTC IS ACTIVE
1. Turn the ignition on.
2. Using the scan tool, read ABS DTCs.
  Is the DTC active at this time?
  
  Yes
  - Go To 2
  No
  - Perform the NO RESPONSE FROM YRS (DYNAMICS SENSOR) diagnostic procedure. Refer to NO RESPONSE FROM YRS (DYNAMICS SENSOR) .
VERIFY THAT THE DYNAMICS SENSOR IS ACTIVE ON THE BUS
1. Using the scan tool, select Network Diagnostics.
2. Verify that the Dynamics Sensor is active on the bus.
  Is the Dynamics Sensor active on the bus?
  
  Yes
  - Go To 3
  No
  - Perform the NO RESPONSE FROM YRS (DYNAMICS SENSOR) diagnostic procedure. Refer to NO RESPONSE FROM YRS (DYNAMICS SENSOR) .
ANTI-LOCK BRAKE SYSTEM (ABS) MODULE
WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
1. Turn the ignition off.
2. Replace the Anti-lock Brake System (ABS) Module in accordance with the Service Information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM, REMOVAL .
3. Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
4. Turn the ignition on.
5. Using the scan tool, read ABS DTCs.
  Does the DTC remain active?
  
  Yes
  - Replace the Dynamics Sensor in accordance with service information. Refer to SENSOR, DYNAMICS, REMOVAL .
  - Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
  No
  - Test complete.