Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK FOR AN ACTIVE DTC
NOTE:
The vehicle must remain stationary for 20 minutes before proceeding with this diagnostic procedure.
1. Turn the ignition on.
2. With the scan tool, read TPM Module DTCs and record on the repair order.
3. With the scan tool, erase TPM Module DTCs.
4. Test drive the vehicle at a speed greater than 20 km/h (13 mph) for 10 minutes in order to receive TPM Sensor data and allow for the system to update.
5. With the scan tool, read TPM Module DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Go To 3
TIRE PRESSURE MONITORING (TPM) MODULE INTERFERENCE
NOTE:
Interference may occur if the TPM Module is installed incorrectly or the TPM harness is not fastened properly to the body.
1. Turn the ignition off.
2. Verify the following:
  - Aftermarket devices are installed or in the vehicle.
  - The TPM Module harness is damaged or is routed incorrectly.
  - The TPM Module is installed incorrectly.
  Are there any of the above conditions present?
  
  Yes
  - Repair as necessary.
  - Perform the TPM VERIFICATION TEST. Refer to TPM VERIFICATION .
  No
  - Install a new Tire Pressure Monitoring (TPM) Module in accordance with the Service Information. Refer to MODULE, TIRE PRESSURE MONITORING (TPM), REMOVAL .
  - Perform the TPM VERIFICATION TEST. Refer to TPM VERIFICATION .
INTERMITTENT TIRE PRESSURE MONITORING (TPM) SENSOR DTC
1. The conditions necessary to set this DTC are not present at this time.
2. Perform any Service Bulletins that may apply to this condition.
3. With the scan tool, erase TPM Module DTCs.
4. Test drive the vehicle for a minimum of 20 minutes with vehicle speed greater than 20 km/h (13 mph).
5. With the scan tool, read TPM Module DTCs.
  Did the DTC return?
  
  Yes
  - Install a new Tire Pressure Monitoring (TPM) Module in accordance with the Service Information. Refer to MODULE, TIRE PRESSURE MONITORING (TPM), REMOVAL .
  - Perform the TPM VERIFICATION TEST. Refer to TPM VERIFICATION .
  No
  - Test complete.
  - Perform the TPM VERIFICATION TEST. Refer to TPM VERIFICATION .