Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK FOR MULTIPLE DTCS
1. With the scan tool, record the Environmental Data for this DTC.
2. Clear the DTC.
3. Ignition off wait at least one minute.
4. Turn the Ignition on, Vehicle in ready mode.
5. With the scan tool check for active DTCs.
  Did DTCs other than P0C17-00 set?
  
  Yes
  
  Diagnose these DTCs first in accordance with the service information.
  
  No
  - Go To 2
CHECK IF THE DTC IS ACTIVE
1. With the scan tool, record the Environmental Data for this DTC.
2. Clear the DTC.
3. Ignition off wait at least one minute.
4. Turn the Ignition on, Vehicle in ready mode.
5. With the scan tool check for active DTCs.
  Did the DTC reset?
  
  Yes
  - Go To 3
  No
  - The Conditions that set this DTC are no longer present.
  - Using the schematics as a guide, check the Power Inverter Module (PIM) pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits.
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .
RESOLVER RELEARN PROCEDURE
1. Position the vehicle on a hoist, and raise the vehicle until the front tires are approximately 30 cm. (12 in.) from the ground.
2. Connect the scan tool to the diagnostics connector. The diagnostic connector is located under the lower steering column cover to the left of the steering column.
3. Enter the vehicle and make sure the vehicle doors are closed to prevent the Automatic Shift to Park function from engaging during the test.
4. Switch the Ignition to READY mode.
5. turn off the Electronic Stability Control (ESC) button on the instrument panel.
6. Carry out the Resolver Relearn procedure by following the step-by-step instructions on the scan tool.
  Was the Resolver Relearn Procedure successful?
  
  Yes
  - Test complete.
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .
  No
  - Go To 4
CHECK IF THE DTC IS ACTIVE
1. With the scan tool, record the Environmental Data for this DTC.
2. Clear the DTC.
3. Ignition off wait at least one minute.
4. Turn the Ignition on, Vehicle in ready mode.
5. With the scan tool check for active DTCs.
  Did the DTC reset?
  
  Yes
  - Replace the Power Inverter Module (PIM) in accordance to the service procedure. Refer to MODULE, POWER INVERTER (PIM), REMOVAL .
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .
  No
  - The Conditions that set this DTC are no longer present.
  - Using the schematics as a guide, check the Power Inverter Module (PIM) pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits.
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .