LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Turbo, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 ((Power Inverter Module (PIM) - Electrical Diagnostics - 500 - Electric)) >> DTC Troubleshooting >> P0BEA-00-Drive Motor A Inverter Phase V Current Sensor Circuit Performance >> Possible Causes

Possible Causes

WARNING: This page is about a different variant/trim than selected.
Possible Causes
3 PHASE CABLES
e-MOTOR
POWER INVERTER MODULE (PIM)
WARNING:

On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury.

Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE to perform the High Voltage Power Down procedure.

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Refer to PIM PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE .