Diagnostic Test

POWER INVERTER MODULE 

1. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
2. Look for any chafed, pierced, pinched or partially broken wires.
3. Look for broken, bent, pushed out or corroded terminals. Verify that there is good pin to terminal contact.
4. Refer to any Technical Service Bulletins that may apply.

   Were there any problems found?

   Yes 

   • Repair as necessary.
   • Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .

   No 

   • Replace the Power Inverter Module (PIM). Refer to MODULE, POWER INVERTER (PIM), REMOVAL .
   • Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .