Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

Electric Vehicle Control Unit (EVCU) DTCs
1. Turn the ignition on.
2. With the scan tool, view DTCs in the EVCU Module.
  Are there any EVCU DTCs present?
  
  Yes
  - Perform the appropriate EVCU diagnostics in accordance with the service information.
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .
  No
  - Go To 2.
CHECK THE OBCM WAKE-UP SIGNAL CIRCUIT FOR A SHORT TO ANOTHER CIRCUIT
1. Turn the ignition off.
2. Disconnect the OBCM C1 harness connector.
3. Disconnect the EVCU C1 harness connector.
4. Measure the resistance between the OBCM Wake-up Signal circuit and all other circuits at the OBCM C1 harness connector.
  Is the resistance above 10k Ohms between the OBCM Wake-up Signal circuit and all other circuits?
  
  Yes
  - Go To 3.
  No
  - Repair the OBCM Wake-up Signal circuit for a short to the circuit that measured below 10k Ohms.
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .
CHECK THE OBCM WAKE-UP SIGNAL CIRCUIT FOR AN OPEN/HIGH RESISTANCE
1. Measure the resistance of the OBCM Wake-up Signal circuit between the OBCM harness connector and the EVCU harness connector.
  Is the resistance below 5.0 Ohms?
  
  Yes
  - Go To 4.
  No
  - Repair the OBCM Wake-up Signal circuit for an open or high resistance.
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .
CHECK THE GROUND CIRCUIT FOR AN OPEN/HIGH RESISTANCE
1. Measure the resistance of the Ground circuit between the OBCM harness connector and the EVCU harness connector.
  Is the resistance below 5.0 Ohms?
  
  Yes
  - Go To 5.
  No
  - Repair the Ground circuit for an open or high resistance.
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .
ON-BOARD CHARGING MODULE
1. Using the wiring diagram/schematic as a guide, inspect the connectors at the Charge Port connector and the On-Board Charging Module (OBCM).
2. Look for broken, bent, pushed out or corroded terminals.
3. Perform any Technical Service Bulletins that may apply.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .
  No
  - Replace the On-Board Charging Module in accordance with the service information. Refer to MODULE, ON-BOARD CHARGING (OBCM), REMOVAL .
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .