Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK EVSE CHARGING CAPABILITY
1. Connect the customers EVSE charging unit to the vehicle. Using the Scan Tool, Monitor the AC output.
  Is the EVSE charging unit operating correctly?
  
  Yes
  - Advise the customer that the problem may be with their power source connection for the EVSE charging unit.
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .
  No
  - Go To 2
CHECK EVSE CHARGING UNIT
1. Refer to the EVSE User manual information and follow the troubleshooting guide to determine if the problem is with the EVSE charging unit or the vehicle.
2. Using the Scan Tool, Monitor the AC output.
  Is the EVSE charging unit operating correctly?
  
  Yes
  - Go To 3
  No
  - Replace the EVSE charging unit in accordance with the service information.
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .
ON-BOARD CHARGING MODULE
1. Using the wiring diagram/schematic as a guide, inspect the connectors at the Charge Port connector and the On Board Charging Module (OBCM).
2. Look for broken, bent, pushed out or corroded terminals.
3. Perform any Technical Service Bulletins that may apply.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .
  No
  - Replace the On-Board Charging Module in accordance with the service information. Refer to MODULE, ON-BOARD CHARGING (OBCM), REMOVAL .
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .