Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
CHECK FOR AN ACTIVE DTC
- Turn the ignition on.
- With the scan tool, read EPS DTCs and record on the vehicle work order.
- With the scan tool, erase DTCs.
- Start the engine and run for two minutes.
- Turn the steering wheel from stop to stop.
- With the scan tool, read EPS DTCs.
Is the DTC active?
Yes
- Replace the Instrument Panel Cluster (IPC) in accordance with service information. Refer to REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring harness and electrical connectors.
- Perform the EPS VERIFICATION TEST. Refer to EPS VERIFICATION TEST .