Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

VERIFY THE DTC IS ACTIVE

NOTE:

This DTC must be active for the results of this test to be valid.

Ignition on, engine not running.
With the scan tool, read DTCs and record on vehicle work order.
With the scan tool, erase DTCs.
Start the engine and run for two minutes.
With the scan tool, read DTCs.
Is the DTC active at this time?

Yes
- Replace the Electronic Power Steering (EPS) Assembly in accordance with service information. Refer to COLUMN, REMOVAL .
- Perform the EPS VERIFICATION TEST. Refer to EPS VERIFICATION TEST .
No
- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring harness and electrical connectors.
- Perform the EPS VERIFICATION TEST. Refer to EPS VERIFICATION TEST .