Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on, in ready mode.
2. Using the scan tool, record and erase EAC DTCs.
3. Turn the ignition off. Wait one minute.
4. Turn the ignition on, in ready mode, Wait one minute.
5. Using the scan tool, read DTCs.
  NOTE:
  If any other HV DTCs are present, diagnose those DTCs first.
  
  Does the scan tool display this DTC as active with no other High Voltage System DTCs?
  
  Yes
  - Go To 2.
  No
  - The condition that caused this code to set is not present at this time. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK FOR BATTERY PACK CONTROL MODULE (BPCM) DTCS
1. Turn the ignition on.
2. With the scan tool, read active DTCs.
  Are any Battery Pack Control Module (BPCM) DTCs present?
  
  Yes
  - Perform the written diagnostic procedure for those DTC's
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .
  No
  - Go To 3.
CHECK THE WIRING AND CONNECTORS
1. The conditions necessary to set the DTC are not present at this time.
2. With the scan tool, check the Environmental Data to help identify the conditions in which the DTC was set.
3. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
4. Wiggle the wiring and connectors while checking for shorted and open circuits.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Test complete.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .