Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK IF THE DTC IS ACTIVE
1. With the scan tool, read Electric Vehicle Control Unit (EVCU) DTCs.
  Is the status for this DTC Active?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
CHECK THE (C21) A/C SHUTOFF VALVE CONTROL CIRCUIT FOR A SHORT TO VOLTAGE
1. Turn the ignition off.
2. Disconnect the EVCU C2 harness connector.
3. Disconnect the A/C Shutoff Valve harness connector.
4. Turn the ignition on.
5. Measure the voltage of (C21) A/C Shutoff Valve Control circuit.
  Is there any voltage present?
  
  Yes
  - Repair the (C21) A/C Shutoff Valve Control circuit for a short to voltage.
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .
  No
  - Go To 3
CHECK THE A/C SHUTOFF VALVE
1. Replace the A/C Shutoff Valve in accordance with the Service Information. Refer to LINE, A/C LIQUID, REMOVAL .
2. Turn the ignition on.
3. With the scan tool, erase EVCU DTCs.
4. Cycle the ignition off and then on.
5. With the scan tool, read EVCU DTCs.
  Does this DTC reset?
  
  Yes
  - Go To 4
  No
  - Test Complete
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .
ELECTRIC VEHICLE CONTROL UNIT (EVCU)
1. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors between the A/C Shutoff Valve and the Electric Vehicle Control Unit (EVCU).
2. Look for any chafed, pierced, pinched or partially broken wires.
3. Look for broken, bent, pushed out or corroded terminals.
4. Perform any Technical Service Bulletins that may apply.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .
  No
  - Replace and program the Electric Vehicle Control Module (EVCU) in accordance with the Service Information. Refer to UNIT, ELECTRIC VEHICLE CONTROL (EVCU), REMOVAL .
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .