Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK IF DTC IS CURRENT
1. Using the scan tool, read EVCU DTCs.
2. Record the Environmental Data and any DTCs.
3. Clear DTCs.
4. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
5. Read EVCU DTCs.
  Did the DTC reset?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION
CHECK THE POWER ELECTRONICS COOLING SYSTEM
1. Turn the ignition off.
2. Check the Hybrid/EV Battery Pack Cooling System for low coolant level.
3. Check the Hybrid/EV Battery Pack Cooling System for coolant contamination.
4. Check the Hybrid/EV Battery Pack Cooling System for restricted air flow.
  Was any of the above problems found in the Hybrid/EV Battery Pack Cooling System?
  
  Yes
  - Repair as necessary in accordance with the Service Information.
  - Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST
  No
  - Refer to DTC INDEX .