Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK FOR AN ACTIVE DTC

With the scan tool, read Body Control Module (BCM) DTCs and record on the repair order.
Is the DTC as active?

Yes
- Replace the Body Control Module (BCM) in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension. If no problems are found, test complete.