Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK FOR AN ACTIVE DIAGNOSTIC TROUBLE CODE (DTC)
1. Turn the ignition on.
2. With the scan tool, read DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE CHARGE INDICATOR LAMP FOR AN INTERNAL SHORT TO VOLTAGE
1. Turn the ignition off.
2. Disconnect the Charge Indicator Lamp harness connector.
3. Turn the ignition on.
4. Measure the voltage of the (G132) Charge Temperature Indicator Signal circuit.
  Is the voltage above 5.0 volts?
  
  Yes
  - Go To 3
  No
  - Replace the Charge Indicator Lamp in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE (G132) CHARGE TEMPERATURE INDICATOR SIGNAL CIRCUIT FOR A SHORT TO VOLTAGE
1. Turn the ignition off.
2. Disconnect the BCM C3 harness connector.
3. Turn the ignition on.
4. Measure the voltage of the (G132) Charge Temperature Indicator Signal circuit.
  Is the voltage present?
  
  Yes
  - Repair the (G132) Charge Temperature Indicator Signal circuit for a short to voltage.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Body Control Module (BCM) in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .