Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
CHECK IF THE DTC IS ACTIVE
NOTE:
With a scan tool, refer to the Network Review screen to aid in identifying vehicle communication problems. The screen depicts a high level view of the vehicle network and any controllers reporting communication problems will appear in red. The CAN C Bus modules are connected in series, to follow the order, refer to the topology listed on the scan tool. Disconnecting a module will remove that module and all the modules downstream of that module from the CAN C bus which will prevent scan tool communication with those modules.
- Turn the ignition on.
- With a scan tool, read Battery Pack Control Module (BPCM) DTCs.
Is the status of this DTC Active?
Yes
- Refer to NO RESPONSE FROM PIM (POWER INVERTER MODULE) and perform the No Response from PIM diagnostic procedure.
No
- Refer to STORED LOST COMMUNICATION DTCS and perform the Stored Lost Communication DTCs diagnostic procedure.