Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK FOR ACTIVE DTC P1E25-00 HYBRID/EV BATTERY FAILURE LEVEL 2
1. Turn the ignition on. Wait 3 minutes.
2. With the scan tool, read DTCs.
  NOTE:
  If other HV Module DTCs are present, diagnose those DTCs first before continuing.
  
  Is the status Active for DTC P1E25-00 HYBRID/EV BATTERY FAILURE LEVEL 2 and also this DTC?
  
  Yes
  - Go To 2
  No
  - Replace the High Voltage Battery Pack in accordance with the Service Information. Refer to BATTERY, HIGH-VOLTAGE, REMOVAL .
  - Perform the BATTERY PACK CONTROL MODULE (BPCM) VERIFICATION TEST. Refer to BPCM VERIFICATION TEST .
BATTERY PACK CONTROL MODULE ACTIVE DTCs
1. Verify that no other DTCs are set in the Battery Pack Control Module (BPCM) other than this DTC.
  Are any other DTCs set in the BPCM?
  
  Yes
  - Perform the diagnostic procedure for those DTCs before continuing.
  - Perform the BATTERY PACK CONTROL MODULE (BPCM) VERIFICATION TEST. Refer to BPCM VERIFICATION TEST .
  No
  - Replace the High Voltage Battery Pack in accordance with the Service Information. Refer to BATTERY, HIGH-VOLTAGE, REMOVAL .
  - Perform the BATTERY PACK CONTROL MODULE (BPCM) VERIFICATION TEST. Refer to BPCM VERIFICATION TEST .