Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

ACTIVE DTC
NOTE:
Diagnose any CAN Bus communication DTCs before continuing.
1. Turn the ignition on.
2. With the scan tool, record and erase BPCM DTCs.
3. Turn the ignition off. Wait 3 minutes.
4. Turn the ignition on. Wait 3 minutes.
5. With the scan tool, read DTCs.
  Is the status Active for this DTC?
  
  Yes
  - Go To 2
  No
  - The condition or conditions that originally set this DTC are not present at this time. Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
RESET THE CLOSED CONTACTOR FAULT
1. With the scan tool, perform the Reset Weld Check Fault procedure located in the BPCM Misc Functions menu.
2. Turn the Ignition on, wait 3 minutes, turn the ignition off, wait 3 minutes. repeat this action 10 times to reset the Closed Contactor fault.
3. With the scan tool, read DTCs.
  Is the status still Active for this DTC?
  
  Yes
  - Replace the High Voltage Battery Pack in accordance with the Service Information. Refer to BATTERY, HIGH-VOLTAGE, REMOVAL .
  - Perform the BATTERY PACK CONTROL MODULE (BPCM) VERIFICATION TEST. Refer to BPCM VERIFICATION TEST .
  No
  - The condition or conditions that originally set this DTC are not present at this time. Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .