Possible Causes
WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
| Possible Causes |
|---|
| DTCS RELATED TO BATTERY VOLTAGE, IGNITION, OR VIN MESSAGES |
| BCM NOT CONFIGURED CORRECTLY |
| EVCU POWER AND GROUND |
| ELECTRIC VEHICLE CONTROL UNIT (EVCU) |
| MODULE THAT SET THIS DTC |
WARNING:
On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Refer to HIGH-VOLTAGE POWER DOWN PROCEDURE . Failure to follow these instructions may result in possible serious or fatal injury.
NOTE: When performing any key-on procedure you must charge the 12 volt battery with a setting of 20 amps minimum or the High Voltage Battery could discharge below recommended manufacture specifications and destroy the battery cells.