Diagnostic Test
WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR AN ACTIVE DIAGNOSTIC TROUBLE CODE (DTC)
- Turn the ignition on.
- With the scan tool, read DTCs.
Does the scan tool display this DTC as active?
Yes
- Go To 2
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. Refer to BODY CONTROL MODULE (BCM) - BODY VERIFICATION TEST - 500 - ELECTRIC .
- CHECK THE CHARGE INDICATOR LAMP FOR AN INTERNAL SHORT TO GROUND
- Turn the ignition off.
- Disconnect the Charge Indicator Lamp harness connector.
- Turn the ignition on.
- With the scan tool, read DTCs.
Does the scan tool display this DTC as active?
Yes
- Go To 3
No
- Replace the Charge Indicator Lamp in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to BODY CONTROL MODULE (BCM) - BODY VERIFICATION TEST - 500 - ELECTRIC .
- CHECK THE (G312) CHARGE INDICATOR LED 2 CIRCUIT FOR A SHORT TO GROUND
- Turn the ignition off.
- Disconnect the BCM C3 harness connector.
- Measure the resistance between ground and the (G312) Charge Indicator LED 2 circuit.
Is the resistance above 10k Ohms?
Yes
- Replace the Body Control Module (BCM) in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY CONTROL MODULE (BCM) - BODY VERIFICATION TEST - 500 - ELECTRIC .
No
- Repair the (G312) Charge Indicator LED 2 circuit for a short to ground.
- Perform the BODY VERIFICATION TEST. Refer to BODY CONTROL MODULE (BCM) - BODY VERIFICATION TEST - 500 - ELECTRIC .