Section 94 (Charging (Service Information) 500): Generator: Installation: Installation

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Generator & Fasteners

Courtesy of CHRYSLER GROUP, LLC

Carefully position the generator (3) up to the engine block and loosely install the bottom two generator mounting bolts (2).
Install the top generator mounting bolts (1).
Tighten the generator mounting bolts to 25 N.m (18 ft. lbs.).
Install the generator B+ cable on the generator stud. Tighten nut to 4 N.m (36 In. lbs.).
Connect the field generator harness connector.

Fig 2: Identifying Intermediate Shaft Support Bearing Retainer Bolts
Courtesy of CHRYSLER GROUP, LLC
Install the intermediate shaft and right side axle shaft. Refer to INSTALLATION .

Fig 3: Belly Pan
Courtesy of CHRYSLER GROUP, LLC
Install the belly pan (1). Refer to BELLY PAN, INSTALLATION .
Lower the vehicle.

Fig 4: Drive Belt Tensioners & Assembly With Drive Belt Routing
Courtesy of CHRYSLER GROUP, LLC
Install the accessory drive belt (4). Refer to BELT, SERPENTINE, INSTALLATION .
Connect the negative battery cable and tighten nut to 5 N.m 45 in. lbs.).
Start the engine and verify the generator is operating properly.