LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Turbo, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Heated Seats (Service Information) 500 - Except Electric) >> Relay, Heated Seat >> Removal >> Removal

Relay, Heated Seat: Removal: Removal

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Disable the airbag system before attempting any front seat diagnosis or service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury. Refer to WARNING .

Fig 1: Heated Seat Relay, Relay Receptacle, Cover & Front Seat
GC0152987Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Open the cover (1) on the relay receptacle (3), located underneath the front seat (4) being serviced.
  3. Remove the heated seat relay (2) from the relay receptacle.
scientia non olet · About LEMON Manuals