LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Turbo, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 ((Regenerative Brake Controller (RBC) - Electrical Diagnostics - 500 - Electric)) >> DTC Troubleshooting >> C10DD-86-PRESURE Sensor Sense Piston - Signal Invalid >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

REGENERATIVE BRAKE CONTROLLER (RBC) 

  1. The Regenerative Brake Controller (RBC) is reporting internal errors.
    NOTE:

    Before continuing, check the Regenerative Brake Controller (RBC) harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.

  2. Using the schematics as a guide, inspect the wire harness and connectors. Pay particular attention to all Power and Ground circuits.
  3. Perform any Technical Service Bulletins that may apply.

    Were there any problems found?

    Yes 

    No