LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Turbo, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Aw60T/6F25 Automatic Transmission (Service Information) 500 - 1.4L 16-Valve) >> Diagnosis And Testing >> Preliminary >> Vehicle Is Disabled

Vehicle Is Disabled

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Record all DTCs and the accompanying DTC Event Data.
  2. With engine running, place transmission in gear and verify correct PRNDL reading. Observe the Input and Output speeds using the scan tool. If output RPM is greater than zero but vehicle does not move, check for transfer case in Neutral (or failed internally), failed propshaft, or failed / disconnected drive axle. If output RPM is zero and input RPM is greater than zero, internal transmission slippage is indicated. Run clutch slip tests using the scan tool, check oil pan for debris, and air check the various clutch circuits.
  3. Shift the transmission into neutral, if both input and output speeds are zero, check drive plate bolts, torque converter, and transmission input shaft.
  4. Remove, inspect, and repair the transmission as necessary
scientia non olet · About LEMON Manuals