LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Turbo, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (C510 Manual Transmission (Service Information) 500 - 1.4L Turbo) >> Cable, Gearshift Control >> Installation >> Installation

Cable, Gearshift Control: Installation: Installation

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install gearshift cable assembly through floor pan opening.
  2. Route the gearshift cable assembly into engine compartment and over transaxle assembly.
  3. Raise the vehicle.
  4. Install the gearshift cable assembly grommet into the opening in the floor pan, seat the grommet completely.
  5. Reposition the underbody heat shield.
    Fig 1: Underbody Retaining Clip
    GC0152843Courtesy of CHRYSLER GROUP, LLC
  6. Install the gearshift cable to the bracket and install the clip (1).
  7. Lower the vehicle.
    Fig 2: Collars
    GC0157836Courtesy of CHRYSLER GROUP, LLC
  8. Connect the cable to the mounting bracket (1).
    Fig 3: Shift Cable
    GC0152839Courtesy of CHRYSLER GROUP, LLC
  9. Connect the shifter cable to the shift lever.
    Fig 4: Shifter Selector Cable On Selector Lever
    GC0152838Courtesy of CHRYSLER GROUP, LLC
  10. Connect the shifter selector cable to the selector lever.
  11. Install the battery tray assembly. Refer to TRAY, BATTERY, INSTALLATION .
    Fig 5: Horse Shoe Reinforcement Bracket
    GC0152842Courtesy of CHRYSLER GROUP, LLC
  12. Install the horse shoe reinforcement bracket, tighten the bolts to 30 N.m (22 ft. lbs.).
  13. Install the shifter. Refer to MECHANISM, GEARSHIFT, INSTALLATION  .
scientia non olet · About LEMON Manuals