Sensor, Manifold Air Pressure (Map): Installation: 1.4L

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: IAT/MAP Sensor O-Ring

Courtesy of CHRYSLER GROUP, LLC

NOTE:

This sensor monitors both Inlet Air Temperature (IAT) and Manifold Air Pressure (MAP).

The IAT/MAP sensor O-ring (1) can be reused if not damaged.
Apply a small amount of engine oil to the sensor O-ring (1).

Fig 2: IAT/MAP Sensor Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Install the IAT/MAP sensor (1) into the intake manifold with the bolt (2) tightened to 9 N.m (80 in. lbs.).
Connect and lock the wire harness connector (3) to the sensor.

Fig 3: Air Cleaner Assembly, Intake Hose, Fittings & Clamp
Courtesy of CHRYSLER GROUP, LLC
Install the air cleaner body (1). Refer to BODY, AIR CLEANER, INSTALLATION .
Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).