Sensor, Air Temperature, Intake: Removal: 1.4L
WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This sensor monitors both Inlet Air Temperature (IAT) and Manifold Air Pressure (MAP).
- Disconnect and isolate the negative battery cable.
- Remove the engine cover.
- Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL .
- Unlock and disconnect the wire harness connector (1) from the IAT/MAP sensor.
- Remove the bolt and the IAT/MAP sensor from the intake manifold.
- The IAT/MAP sensor O-ring (1) can be reused if not damaged.