Sensor, Air Temperature, Intake: Removal: Removal

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Cover

Courtesy of CHRYSLER GROUP, LLC

NOTE:

This sensor monitors both Inlet Air Temperature (IAT) and Manifold Air Pressure (MAP).

Disconnect and isolate the negative battery cable.
Remove the engine cover (1).

Fig 2: Air Cleaner Body Assembly
Courtesy of CHRYSLER GROUP, LLC
Remove the air cleaner body (6). Refer to BODY, AIR CLEANER, REMOVAL .

Fig 3: IAT/MAP Sensor, Connector & Bolt
Courtesy of CHRYSLER GROUP, LLC
Unlock and disconnect the electrical connector (1) from the IAT/MAP sensor.
Remove the bolt and the IAT/MAP sensor from the intake manifold.

Fig 4: IAT/MAP Sensor O-Ring
Courtesy of CHRYSLER GROUP, LLC
The IAT/MAP sensor O-ring (1) can be reused if not damaged.