Set Condition
WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
This secondary fault is set if the primary fault is not set initially. The vehicle is shut down and can not or will not start. This DTC will also set if the high voltage Service Disconnect is removed from the vehicle and the ignition is on. The MIL is illuminated when the DTC is Active. The Stored DTC does not set the MIL and is erased after 40 key cycles. If this DTC is erased using the scan tool, it may take up to 3 minutes before the code will clear.