LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Turbo, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Electronic Control Modules (Service Information) 500 - Except Electric) >> Module, Powertrain Control >> Removal >> 1.4L I4 16V

1.4L I4 16V

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: PCM Electrical Connectors
GC0152393Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and remove the battery (Refer to REMOVAL ).
  2. Disconnect the Powertrain Control Module (PCM) electrical connectors (1 and 2).
    Fig 2: Battery Tray, Connectors, Retainers, Nut & Bolts
    GC0152563Courtesy of CHRYSLER GROUP, LLC
  3. Disengage two starter wire harness retainers (6) from the battery tray (3).
  4. Disengage two engine wire harness retainers (4) from the battery tray (3).
  5. Disengage the engine wire harness connector (2) from the battery tray (3) and reposition the wire harness.
  6. Remove the nut (5) and two bolts (1).
    Fig 3: PCM, Retainers, Ground Strap & Nuts
    GC0152394Courtesy of CHRYSLER GROUP, LLC
  7. Open the two wire harness retainers (3) and reposition the wire harness.
  8. Remove the battery tray with the PCM (2) attached.
  9. Remove the four nuts (1) with ground strap (4) and remove the PCM (2) from the battery tray.
scientia non olet · About LEMON Manuals