LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Turbo, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Electronic Control Modules (Service Information) 500 - Except Electric) >> Module, Body Control >> Removal >> Removal

Module, Body Control: Removal: Removal

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Drivers Side Close Out Panel & Knee Blocker Airbag
GC0152725Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect, and isolate the negative battery cable.
  2. Remove the drivers side close out panel (1).
  3. Remove the driver knee blocker (2). Refer to AIR BAG, KNEE BLOCKER, REMOVAL .
    Fig 2: Four Electrical Connectors & BCM
    GC0152726Courtesy of CHRYSLER GROUP, LLC
  4. Remove the two fasteners, and remove the fuse box cover.
  5. Disconnect the four electrical connectors (1) on the front side of the Body Control Module (BCM) (2).
    Fig 3: Three Fasteners, BCM, Mounting Bracket
    GC0152727Courtesy of CHRYSLER GROUP, LLC
  6. Remove the three fasteners (1) that secure the BCM (2) to the mounting bracket (3); two on the top, and one on the bottom.
  7. Lift the BCM up far enough to clear the lower mounting point on the bracket.
    NOTE:

    It will be necessary to position the bracket downward when removing the BCM.

    CAUTION:

    Do not distort the BCM bracket in excess, when repositioning.

  8. Pull the BCM forward and down to remove from the bracket.
  9. Disconnect the two electrical connectors from the back, and remove the BCM from the vehicle.
scientia non olet · About LEMON Manuals