LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Turbo, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Base Brakes (Service Information) 500 - Except Electric) >> Standard Procedure >> Standard Procedure - Base Brake Bleeding >> Pressure Bleeding

Pressure Bleeding

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Follow pressure bleeder manufacturer instructions for use of pressure bleeding equipment.

  1. Install pressure bleeding equipment by following the pressure bleeder manufacturer instructions.
    Fig 1: Bleeding Brakes
    GC0079789Courtesy of CHRYSLER GROUP, LLC
  2. Attach a clear plastic hose (1) to the bleeder screw and feed the hose into a clear jar (2) containing enough fresh brake fluid to submerge the end of the hose.
  3. Open the bleeder screw at least one full turn or more to obtain a steady stream of brake fluid.
  4. After approximately 120-240 ml (4-8 ounces) of fluid have been bled through the brake circuit and an air-free flow is maintained in the clear plastic hose and jar, close the bleeder screw.
  5. Repeat this procedure at all the remaining bleeder screws.
    Fig 2: Master Cylinder Fill Markings
    GC0083906Courtesy of CHRYSLER GROUP, LLC
  6. Check and adjust brake fluid level to the FULL mark on the reservoir (2).
  7. Check the brake pedal travel. If pedal travel is excessive or has not been improved, some air may still be trapped in the system. Re-bleed the brakes as necessary.
  8. Test drive the vehicle to verify the brakes are operating properly and pedal feel is correct.
scientia non olet · About LEMON Manuals