Switch, Oil Pressure: Removal: Removal
WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The oil pressure switch has a lock patch on the threads and if removed can not be reinstalled.
- Disconnect and isolate the negative battery cable.
- Raise and support the vehicle.
Refer to HOISTING .
- Remove two bolts (4) and the right vertical brace (5).
- Remove the two screws (2) from the front wheelhouse splash shield.
- Remove the three screws (1) and the frame splash shield (3).
- Disconnect the oil pressure switch electrical connector (1).
- Remove the oil pressure switch (2) from the oil pump housing.