LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Turbo, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (1.4L 16-Valve Turbo Engine (Service Information) 500) >> Engine Mounting >> Insulator, Engine Mount, Left >> Removal >> Removal

Insulator, Engine Mount, Left: Removal: Removal

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Air Cleaner Assembly, Intake Hose, Fittings & Clamp
GC0153787Courtesy of CHRYSLER GROUP, LLC
  1. Remove the air cleaner body (1). Refer to BODY, AIR CLEANER, REMOVAL .
    Fig 2: PCM Electrical Connectors
    GC0152393Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    When servicing components near the vacuum pump, avoid contact with the plastic nipple that connects the vacuum pump to the brake booster hose. It is possible to crack the plastic nipple resulting in a brake booster vacuum leak.

  2. Disconnect and remove the battery. Refer to BATTERY, REMOVAL .
  3. Disconnect the Powertrain Control Module (PCM) harness connectors (1 and 2).
    Fig 3: Battery Tray, Connectors, Retainers, Nut & Bolts
    GC0152563Courtesy of CHRYSLER GROUP, LLC
  4. Disengage two starter wire harness retainers (6) from the battery tray (3).
  5. Disengage two engine wire harness retainers (4) from the battery tray (3).
  6. Disengage the engine wire harness connector (2) from the battery tray (3) and reposition the wire harness.
  7. Remove the nut (5) and two bolts (1).
    Fig 4: PCM, Retainers, Ground Strap & Nuts
    GC0152394Courtesy of CHRYSLER GROUP, LLC
  8. Open the two wire harness retainers (3) and reposition the wire harness.
  9. Remove the nut (1) and the ground strap (4).
  10. Remove the battery tray with the PCM (2) attached.
    Fig 5: Lower Air Dam/Belly Pan
    GC0082359Courtesy of CHRYSLER GROUP, LLC
  11. Raise and support the vehicle. Refer to HOISTING .
  12. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
    Fig 6: Tunnel Support Brace & Bolts
    GC0152449Courtesy of CHRYSLER GROUP, LLC
  13. Remove four bolts (1) and the tunnel support brace (2).
    Fig 7: LH Engine Mount Isolator & Bolts
    GC0152421Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Automatic transmission equipped engine mount shown in illustration, manual transmission equipped engine mount similar.

  14. Support the engine with a floor jack positioned under the transmission.
  15. Remove three bolts (2 and 3) and the LH engine mount isolator (1).
    Fig 8: Left Engine Mount Bracket & Bolts
    GC0152660Courtesy of CHRYSLER GROUP, LLC
  16. If required, remove the three bolts (2) and the left engine mount bracket (1) from the automatic transmission.
    Fig 9: Left Side Mount Bolts
    GC0152988Courtesy of CHRYSLER GROUP, LLC
  17. If required, remove the three bolts (1) and the left engine mount bracket from the manual transmission.
scientia non olet · About LEMON Manuals