With Manual Transmission

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Oil Viscosity Sensor & Connector

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
Raise and support the vehicle. Refer to HOISTING .
Remove the belly pan. Refer to BELLY PAN, REMOVAL .
Drain the engine oil. Refer to STANDARD PROCEDURE .
Remove the viscosity sensor (2).

Fig 2: Upstream And Downstream Oxygen Sensors, Maniverter & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Remove the maniverter (4). Refer to MANIFOLD, EXHAUST, REMOVAL .

Fig 3: Rear Engine Mount Bracket, Isolator & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Raise and support the vehicle. Refer to HOISTING .
Remove the rear engine mount bracket bolt (3) and nut (6).
Remove two bolts (2 and 4) and remove the rear engine mount bracket (5).

Fig 4: Blocker Plate & Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove two bolts (2) and the blocker plate (1) from the oil pan.

Fig 5: Flywheel Dust Cover Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove the two bolts (1) from the flywheel dust cover.

Fig 6: Flywheel Dust Cover & Bolt
Courtesy of CHRYSLER GROUP, LLC

NOTE:
The flywheel dust cover is bolted to the oil pan and cannot be removed at this time.

Fig 7: Transmission Bell Housing Bolts, Nut & Stud
Courtesy of CHRYSLER GROUP, LLC
Remove the two lower transmission bell housing bolts (3).

Fig 8: Oil Pan Flange Fasteners
Courtesy of CHRYSLER GROUP, LLC
Remove fourteen bolts (1), two nuts and two studs (2) from the flange of the oil pan.
Using the four indicated pry points, carefully remove the oil pan and flywheel dust cover.

Fig 9: Flywheel Dust Cover & Bolt
Courtesy of CHRYSLER GROUP, LLC
Remove the bolt (1) and the flywheel dust cover (2) from the oil pan.

Fig 10: Oil Pan Sealant Locations
Courtesy of CHRYSLER GROUP, LLC
Remove all residual sealant (1) from the oil pan, engine block, oil pump and rear seal retainer. Refer to CLEANING .