Module, Power Top Control, Full Open Retractable Roof: Installation: Installation

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Module & Motor

Courtesy of CHRYSLER GROUP, LLC

Position the module (1) onto the mounting plate and press into place, engaging the retaining clips.
Connect the body harness electrical connector to the module (1).

Fig 2: Motor Cover Plate & Rivets
Courtesy of CHRYSLER GROUP, LLC
Position the cover plate (2) and install with four new rivets (1).

Fig 3: Rear Shelf, Bracket & Retainers
Courtesy of CHRYSLER GROUP, LLC
Position the rear shelf (2).
Install the push pin retainers (3) securing the rear shelf.
Align and position the bracket (1) onto the rear shelf.
Install the three fasteners securing the bracket (1) to the rear shelf (2). Tighten the bracket securely.

Fig 4: Rear Wind Deflector/Windscreen
Courtesy of CHRYSLER GROUP, LLC
Install the rear wind deflector / windscreen (1) by aligning and pushing down.
Connect the negative battery cable.