Diagnostic Test

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC

Turn the ignition on.
With the scan tool, read EPS DTCs and record on the vehicle work order.
With the scan tool, erase DTCs.
Start the engine and run for two minutes.
Turn the steering wheel from stop to stop.
With the scan tool, read EPS DTCs.
Is the DTC active?

Yes
- Replace the Instrument Panel Cluster (IPC) in accordance with service information. Refer to REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY CONTROL MODULE (BCM) - BODY VERIFICATION TEST - 500 - EXCEPT ELECTRIC .
No
- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring harness and electrical connectors.
- Perform the EPS VERIFICATION TEST. Refer to EPS VERIFICATION TEST .