LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Turbo, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Body Control Module (BCM) - DTCS B1000-44 To B10AD-12 - 500 - Except Electric) >> DTC Troubleshooting >> B1085-19-Driver Heated Seat Led - Over Current >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. TEST FOR INTERMITTENT CONDITION 
    NOTE:

    Make sure the battery is fully charged and the charging system is operating properly before proceeding.

    1. Turn the ignition on.
    2. Using a scan tool, record and erase Diagnostic Trouble Codes (DTCs).
    3. Turn the ignition off.
    4. Start the engine and let it run.
    5. Using a scan tool, read DTCs.

      Is the DTC active?

      Yes 

      • Go To  2

      No 

      • The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors. Look for chafed, pierced, pinched, or partially broken wires and broken, bent, pushed out, spread, corroded, or contaminated terminals.
      • Perform the BODY VERIFICATION TEST. Refer to BODY CONTROL MODULE (BCM) - BODY VERIFICATION TEST - 500 - EXCEPT ELECTRIC .
  2. CHECK DRIVER SEAT LED DRIVER OUTPUT CIRCUIT FOR A SHORT TO BATTERY 
    1. Turn the ignition off.
    2. Using a 12-volt test light connected to ground, test the Driver Seat Head Driver Output circuit.

      Does the test light illuminate brightly?

      Yes 

      No 

      • Go To  3
  3. CHECK FOR BCM MALFUNCTION 
    1. Using a 12-volt test light connected to ground, test the Driver Seat LED Driver Output circuit.
    2. With the scan tool, actuate the Driver Heated Seat Relay.

      Does the test light illuminate brightly?

      Yes 

      No