Diagnostic Test

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, clear all DTCs.
3. Turn the Fog Lamps on.
4. With the scan tool, read DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to BODY CONTROL MODULE (BCM) - BODY VERIFICATION TEST - 500 - EXCEPT ELECTRIC .
CHECK THE REAR FOG LAMP RELAY
1. Turn the Fog Lamps off.
2. Turn the ignition off.
3. Remove the Rear Fog Lamp Relay and substitute it with a known good relay.
4. Turn the ignition on.
5. Turn the Fog Lamps on.
6. With the scan tool, read DTCs.
  Does the scan tool display DTC: B1024-19-REAR FOG LAMPS - OVER CURRENT?
  
  Yes
  - Go To 3
  No
  - Replace the Rear Fog Lamp Relay.
  - Perform the BODY VERIFICATION TEST. Refer to BODY CONTROL MODULE (BCM) - BODY VERIFICATION TEST - 500 - EXCEPT ELECTRIC .
CHECK THE (L239) REAR FOG LAMP RELAY CONTROL CIRCUIT FOR A SHORT TO VOLTAGE
1. Turn the ignition off.
2. Remove the Rear Fog Lamp Relay.
3. Disconnect the BCM C1 harness connector.
4. Turn the ignition on.
5. Measure the voltage between ground and the (L239) Rear Fog Lamp Relay Control circuit.
  Is there any voltage present?
  
  Yes
  - Repair the short to voltage in the (L239) Rear Fog Lamp Relay Control circuit.
  - Perform the BODY VERIFICATION TEST. Refer to BODY CONTROL MODULE (BCM) - BODY VERIFICATION TEST - 500 - EXCEPT ELECTRIC .
  No
  - Replace the Body Control Module (BCM) in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY CONTROL MODULE (BCM) - BODY VERIFICATION TEST - 500 - EXCEPT ELECTRIC .