Diagnostic Test

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

CHECK IF DTC IS CURRENT

Using the scan tool, read EVCU DTCs.
Record the Environmental Data and any DTCs.
Clear DTCs.
Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
Read EVCU DTCs.
Did the DTC reset?

Yes
- Using the schematics as a guide, check the Electric Vehicle Control Unit (EVCU) pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the EVCU in accordance with the Service Information. Refer to UNIT, ELECTRIC VEHICLE CONTROL (EVCU), REMOVAL .
- Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .