Diagnostic Test
WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
| Typical ePRND Switch Voltages | ||||||
|---|---|---|---|---|---|---|
| Switch | Button Not Pressed - Typical Voltage | Button Not Pressed - Minimum Voltage | Button Not Pressed - Maximum Voltage | Button Pressed - Typical Voltage | Button Pressed - Minimum Voltage | Button Pressed - Maximum Voltage |
| Park Low Side Switch (1) | 1.71 | 1.00 | 2.10 | 3.45 | 3.00 | 4.10 |
| Park High Side Switch (2) | 3.37 | 3.00 | 4.10 | 1.30 | 1.00 | 2.10 |
| Reverse Low Side Switch (1) | 1.71 | 1.00 | 2.10 | 3.45 | 3.00 | 4.10 |
| Reverse High Side Switch (2) | 3.37 | 3.00 | 4.10 | 1.30 | 1.00 | 2.10 |
| Neutral Low Side Switch (1) | 1.71 | 1.00 | 2.10 | 3.45 | 3.00 | 4.10 |
| Neutral High Side Switch (2) | 3.37 | 3.00 | 4.10 | 1.30 | 1.00 | 2.10 |
| Drive Low Side Switch (1) | 1.71 | 1.00 | 2.10 | 3.45 | 3.00 | 4.10 |
| Drive High Side Switch (2) | 3.37 | 3.00 | 4.10 | 1.30 | 1.00 | 2.10 |
NOTE:
Holding any button pressed longer than 10 seconds will set a DTC for button stuck.
- CHECK IF DTC IS CURRENT
- Using the scan tool, read EVCU DTCs.
- Record the Environmental Data and any DTCs.
- Clear DTCs.
- Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
- Read EVCU DTCs.
Did the DTC reset?
Yes
- Go To 2
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
- CHECK THE DRIVE BUTTON OPERATION
- Using the scan tool, and the ePRND Typical Switch Voltage table, operate the Drive Switch and note the voltage for Not Pressed and Pressed.
Does the scan tool show the Drive Button remains in a depressed state after released?
Yes
- Using the schematics as a guide, check the ePRND pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the ePRND in accordance with the Service Information. Refer to SWITCH, ELECTRIC SHIFTER, REMOVAL .
- Perform the EVCU VERIFICATION TEST. Refer to EVCU VERIFICATION TEST .
No
- Condition not present to set this DTC. Holding the Drive button depressed longer than 10 seconds can set this DTC.
- Using the scan tool, and the ePRND Typical Switch Voltage table, operate the Drive Switch and note the voltage for Not Pressed and Pressed.