Possible Causes
WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
| Possible Causes |
|---|
| PRND DRIVE HIGH SIDE SWITCH (2) CIRCUIT SHORTED TO VOLTAGE |
| ePRND MODULE |
| ELECTRIC VEHICLE CONTROL UNIT (EVCU) |
WARNING:
On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury.
NOTE:
When performing any key-on procedure you must charge the 12 volt battery with a setting of 20 amps minimum or the High Voltage Battery could discharge below recommended manufacture specifications and destroy the battery cells
Refer to HIGH-VOLTAGE POWER DOWN PROCEDURE to perform the High Voltage Power Down procedure.
Always perform the Pre-Diagnostic Troubleshooting Procedure before proceeding. Refer to EVCU PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE .