LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Sport, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 54 (Rear Suspension - 500 - Electric) >> Hub And Bearing >> Removal >> Removal

Hub And Bearing: Removal: Removal

WARNING: This page is about a different variant/trim than selected.
Fig 1: Wheel Lug Bolts
GC0152555Courtesy of CHRYSLER GROUP, LLC
NOTE:

Before proceeding, refer to WARNING  .

  1. Raise and support the vehicle. Refer to HOISTING .
  2. Remove the wheel mounting bolts (1), then the rear tire and wheel assembly.
    Fig 2: Wheel Mounting Pins
    GC0152557Courtesy of CHRYSLER GROUP, LLC
  3. Remove the hub and bearing dust cap (2).
  4. Remove the rotor mounting pins (1).
    Fig 3: Caliper Mounting Bolts, Caliper And Mounting Bracket, Brake Rotor, Hub Nut, Washer & Hub And Bearing
    GC0152831Courtesy of CHRYSLER GROUP, LLC
  5. Remove caliper mounting bolts (7) and remove the caliper and mounting bracket (6) as an assembly. Support the assembly with a bungee cord or wire. Do not allow the caliper to hang by the flex hose; damage to the hose may occur. 
  6. Remove the brake rotor (3).
  7. Remove the hub nut (1) and washer (2), then remove the hub and bearing (4).
scientia non olet · About LEMON Manuals