Switch, Electric Shifter: Installation: Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Four Clips & Electronic Shifter Switch

Courtesy of CHRYSLER GROUP, LLC

Install the electronic shifter switch (2) in the bezel until the four clips (1) are engaged.

Fig 2: Three Electrical Connectors
Courtesy of CHRYSLER GROUP, LLC
Connect the three electrical connectors (1) below the electronic shifter switch bezel.

Fig 3: Gear Shifter Switch Bezel
Courtesy of CHRYSLER GROUP, LLC
Install the electronic shifter switch bezel (1).
Connect the negative 12-volt battery cable. Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .