Diagnostic Test

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

EEPROM FAILURE DTC PRESENT

Turn the ignition on.
With the scan tool, read TPM Module DTCs and record on the repair order.
With the scan tool, erase stored DTCs.
Turn the ignition off.
Turn the ignition on.
With the scan tool, read TPM Module DTCs.
Did the DTC return?

Yes
- Replace the Tire Pressure Monitoring (TPM) Module in accordance with the Service Information. Refer to MODULE, TIRE PRESSURE MONITORING (TPM), REMOVAL .
- Perform the TPM VERIFICATION TEST. Refer to STANDARD PROCEDURE - TPM VERIFICATION .
No
- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform the TPM VERIFICATION TEST. Refer to STANDARD PROCEDURE - TPM VERIFICATION .