Removal, Valve Body Wiring Harness

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

Remove the Transmission Control Module (TCM). Refer to MODULE, TRANSMISSION CONTROL, REMOVAL .
Remove the transmission side cover. Refer to VALVE BODY, REMOVAL .

Fig 1: Solenoid/Speed Sensor Connectors
Courtesy of CHRYSLER GROUP, LLC
Disconnect the wire harness from the clamps.
Disconnect the solenoid connectors and the speed sensor connectors (1).

Fig 2: Oil Temperature Sensor, Clamp & Bolt
Courtesy of CHRYSLER GROUP, LLC
Remove the oil temperature sensor bolt (1) and clamp (2). Remove the sensor (3) from the valve body.

Fig 3: Speed Sensor Connector
Courtesy of CHRYSLER GROUP, LLC
Remove the speed sensor connector (1) from the solenoid clamp.

Fig 4: Wiring Harness Loom & Fastener
Courtesy of CHRYSLER GROUP, LLC
Remove the wiring harness loom fastener (2) and remove loom (1).

Fig 5: Connector Retaining Clip
Courtesy of CHRYSLER GROUP, LLC
Remove the wiring harness connector retaining clip (1) and remove the wiring harness from the transmission.

Fig 6: Connector, O-Ring & Gasket
Courtesy of CHRYSLER GROUP, LLC
Remove and discard the O-ring (1) and the gasket (2) from the connector.