LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Sport, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Electronic Control Modules (Service Information) 500 - Except Electric) >> Module, Body Control >> Installation >> Installation

Module, Body Control: Installation: Installation

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Three Fasteners, BCM, Mounting Bracket
GC0152727Courtesy of CHRYSLER GROUP, LLC
  1. Position the Body Control Module (BCM) (2) into the vehicle and connect the two electrical connectors on the back of the module.
  2. Position the BCM in the bracket (3).
    NOTE:

    It will be necessary to position the bracket downward when installing the BCM.

    CAUTION:

    Do not distort the BCM bracket in excess, when repositioning.

  3. Install, and tighten the three fasteners (1) that secure the BCM to the mounting bracket; two on the top, and one on the bottom.
    Fig 2: Four Electrical Connectors & BCM
    GC0152726Courtesy of CHRYSLER GROUP, LLC
  4. Connect the four electrical connectors (1) on the front side of the BCM (2).
  5. Position the fuse box cover; install the two fasteners, and tighten.
    Fig 3: Drivers Side Close Out Panel & Knee Blocker Airbag
    GC0152725Courtesy of CHRYSLER GROUP, LLC
  6. Install the driver knee blocker (2). Refer to AIR BAG, KNEE BLOCKER, INSTALLATION .
  7. Install the driver side close out panel (1).
  8. Connect the negative battery cable.
scientia non olet · About LEMON Manuals