Module, Electronic Shifter (ESM): Installation: Installation

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Electronic Shifter Module (ESM) & Electrical Connectors

Courtesy of CHRYSLER GROUP, LLC

Install the electronic shifter module (ESM) (2).
Connect the two ESM electrical connectors (1).

Fig 2: Center Console Screws & Bolts
Courtesy of CHRYSLER GROUP, LLC
Install the two center console bolts (2), and the two center console screws (1).
Connect the floor console 12-volt outlet electrical connector.

Fig 3: Front Floor Console Nuts
Courtesy of CHRYSLER GROUP, LLC
Install and tighten the two front floor console nuts (1) to 8 Nm (71 in. lbs.), and install the cup holder insert.

Fig 4: Front Floor Console Screws
Courtesy of CHRYSLER GROUP, LLC
Install the two front floor console screws (1).

Fig 5: Floor Console Vent Panel Screws
Courtesy of CHRYSLER GROUP, LLC
Install the two floor console vent panels, and the two floor console vent panel screws (1).

Fig 6: Rear Floor Console Nut
Courtesy of CHRYSLER GROUP, LLC
Install and tighten the rear floor console nut (1) to 8 Nm (71 in. lbs.), and install the rear cup holder insert.

Fig 7: Three Electrical Connectors
Courtesy of CHRYSLER GROUP, LLC
Connect the three electrical connectors (1).

Fig 8: Gear Shifter Switch Bezel
Courtesy of CHRYSLER GROUP, LLC
Install the electronic shifter switch bezel.
Connect the negative 12-volt battery cable. Refer to ELECTRIC VEHICLE CONTROL SYSTEM, STANDARD PROCEDURE .