LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500 Sport, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Electronic Control Modules (Service Information) 500 - Electric) >> Module, A/C And Heater >> Installation >> Installation

Module, A/C And Heater: Installation: Installation

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Air inlet housing removed from view for clarity.

Fig 1: Wire Harness Connector, A/C Heater Module, HVAC Housing, Lower Module Retaining Screw
GC0152611Courtesy of CHRYSLER GROUP, LLC
  1. Position the A/C heater module (2) to the right side of the HVAC housing (5).
    NOTE:

    Use a flexible drive socket to remove the lower module retaining screw (3).

  2. Install the three retaining screws (1 and 3) that secure the module to the housing. Tighten the screws to 0.8 N.m (7 in. lbs.).
  3. Connect the wire harness connector (4) to the A/C heater module.
  4. Install the glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, INSTALLATION .
  5. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals