Cylinder, Clutch Master: Installation: Installation

WARNING: This page is about a different car, the 2015 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Brake Pedal, Brake Master Cylinder & Mounting Nuts

Courtesy of CHRYSLER GROUP, LLC

Install the pedal assembly to the vehicle, tighten the mounting nuts to 16 N.m (12 lb. ft.).
Connect the brake pedal to the brake master cylinder push rod.

Fig 2: Clutch Start & Brake Lamp Switches
Courtesy of CHRYSLER GROUP, LLC
Connect the clutch start (1) and brake lamp switches (2).

Fig 3: Supply Hose
Courtesy of CHRYSLER GROUP, LLC
Install the instrument panel reinforcement. Refer to PANEL, INSTRUMENT, INSTALLATION .
Install the supply hose to the brake master cylinder crimp the new hose clamp with Crimping Pliers (special tool #10288, Pliers, Hose Clamp).

Fig 4: High Pressure Line
Courtesy of CHRYSLER GROUP, LLC
Install the battery tray. Refer to TRAY, BATTERY, INSTALLATION .
Raise the vehicle.
Connect the high pressure line to the master cylinder.
Lower the vehicle.
Bleed the clutch hydraulic circuit. Refer to STANDARD PROCEDURE .