Section 28 (Battery System (Service Information) 500 - Except Electric): Specifications: Specifications

The battery Group Size number, the Cold Cranking Amperage (CCA) rating, and the Reserve Capacity (RC) rating, or Ampere-Hours (AH) rating, can be found on the original equipment battery label. Be certain that a replacement battery has the correct Group Size number, as well as CCA, and RC or AH ratings that equal or exceed the original equipment specification for the vehicle being serviced. Battery sizes and ratings are discussed in more detail below.

• Group Size  - The outside dimensions and terminal placement of the battery conform to standards established by the Battery Council International (BCI). Each battery is assigned a BCI Group Size number to help identify a correct -sized replacement.
• Cold Cranking Amperage  - The Cold Cranking Amperage (CCA) rating specifies how much current (in amperes) the battery can deliver for 30 seconds at -18° C (0° F). Terminal voltage must not fall below 7.2 volts during or after the 30 second discharge period. The CCA required is generally higher as engine displacement increases, depending upon the starter current draw requirements.
• Reserve Capacity  - The Reserve Capacity (RC) rating specifies the time (in minutes) it takes for battery terminal voltage to fall below 10.5 volts, at a discharge rate of 25 amperes. RC is determined with the battery fully-charged at 26.7° C (80° F). This rating estimates how long the battery might last after a charging system failure, under minimum electrical load.
• Ampere-Hours  - The Ampere-Hours (AH) rating specifies the current (in amperes) that a battery can deliver steadily for 20 hours, with the voltage in the battery not falling below 10.5 volts. This rating is sometimes identified as the 20-hour discharge rating.